The Beckett SM oil burner is not dependent upon a combustion chamber for flame stabilization. Instead, it’s available with a choice of six ...
Technical Bulletins
Review our Tech Bulletins to stay up to date on important updates to Beckett products and accessories.
Select category
Select the year
Select the month
Introduction
In order to assist the consumer in purchasing heating appliances that conserve energy, the Department of Energy (D.O.E.) has established test procedures and Annual Fuel Utilization Efficiency ratings (A.F.U.E.). This information is presented on uniform rating labels for ...
Our last issue addressed the electrical areas of the ignition system. This issue discusses two related systems that also can be contributing factors: The air and the oil handling systems.
The Burner Air Handling System
An oil burner delivers adequate combustion air over a wide range of firing ...
To provide you with adequate information on solving delayed ignition problems, we need more than one bulletin. Therefore, this bulletin will consider first the electrical factors involved. The February bulletin will consider all other causes.
Delayed ignition problems can be difficult to ...
We continue to receive many questions regarding our Model AFG burner and its ability to develop “high static pressure”.
This bulletin is intended to briefly explain the purpose of higher static pressure, the key operational components that develop it, and how the burner performance is ...
It’s that time of year: new installations, no-heat calls, annual tune-ups. Each situation calls for proper burner adjustment.
Whether you are installing a new burner, solving a problem, or conducting an annual service call, you eventually get to the point where you have to adjust the burner. ...
Most servicemen have personal strategies that work effectively for them. Results count, so use what methods you find effective. To help you, we have developed the following simplified procedure based on what many servicemen use.
EQUIPMENT
To diagnose burner malfunctions ...
Heating appliance soot-up can be prevented if you know the causes. In this era of increased appliance efficiency, the service industry must stay abreast of new advances and the new requirements that must be met.
Appliances are more compact and streamlined. The emphasis is on AFUE ratings and ...
Condensing-type furnaces, particularly those fired with gas, are becoming accepted in the heating equipment marketplace. Fifteen percent of the gas fired furnaces installed today are condensing-type furnaces. With the U.S. Department of Energy standards set to take effect in 1992, minimum ...
Not all nozzles are exactly alike. There are variations from one manufacturer to another. Conversion charts are good guides, but they do not always take into account the variances.
The problem is that standards do not exist to accurately define hollow and solid. Many methods have been ...
With the introduction of new and improved combustion test instruments, many technicians are asking what the real difference is between measuring oxygen and measuring carbon dioxide. Is one method better than the other? Is the end result the same?
To answer these questions, we will present a ...
We get inquiries concerning upgrading old stoker units where the burner can be fired through the upper fire door or lower ash pit door. In this bulletin we will discuss some guidelines that will enable you to make successful retrofit applications in these older units.
Our experience has shown ...
In the past few years most oil burner manufacturers have introduced “high static pressure” burners. We have received from our technical subjects’ survey many inquiries regarding the function of and need for these new burners. This technical bulletin will address these ...
No results found.